Yamaha Star XVS950A 2009 Service Manual page 65

1. Relay unit
2. Relay unit lead
3. Lean angle sensor lead
4. O sensor lead coupler
2
5. O sensor lead
2
6. Starter motor lead
7. Bracket
8. Taillight lead
9. Rear brake hose
A. Route the seat lock cable under the joint
coupler lead.
B. Clamp the taillight lead, starter motor lead,
main fuse lead and headlight relay lead
with the bracket. Face the end down.
C. Clamp the rear right turn signal light lead
and starter motor lead with the bracket.
Face the end inside.
D. Route the rear right turn signal light lead
and starter motor lead outside of the guide
wire.
E. Clamp the O sensor lead. Face the open-
2
ing outside.
F. Clamp the starter motor lead to the bracket
with the sheet dropping key rotor. Face the
lock inside and down. Cut off the excess
end.
G. Clamp the joint coupler lead and starter
motor lead.
H. Face the lock of the clamp toward outside.
I. Route the taillight lead inner side of the
starter motor lead.
J. Clamp the O sensor lead. Face the clamp
2
opening to outside.
K. Insert the coupler on the harness side of
the O sensor lead to the rear brake hose
2
bracket clamp.
2-42
CABLE ROUTING