Yamaha Star XVS950A 2009 Service Manual page 14

Odometer, tripmeter, and fuel reserve trip-
meter modes
1. Odometer/tripmeter/fuel reserve tripmeter
Push the "SELECT" switch to change the dis-
play between the odometer mode "ODO", the
tripmeter modes "TRIP A" and "TRIP B" in the
following order:
ODO → TRIP A → TRIP B → ODO
If the fuel level warning light comes on, the
odometer display will automatically change to
the fuel reserve tripmeter mode "TRIP F" and
start counting the distance traveled from that
point. In that case, push the "SELECT" switch
to change the display between the various trip-
meter and odometer modes in the following
order:
TRIP F → TRIP A → TRIP B → ODO → TRIP
F
To reset a tripmeter, select it by pushing the
"SELECT" switch, and then push the "RESET"
switch for at least one second. If you do not
reset the fuel reserve tripmeter manually, it will
reset itself automatically, and the display will
return to the prior mode after refueling and
traveling 5 km (3 mi).
Self-diagnosis device
1. Error code display
This model is equipped with a self-diagnosis
device for various electrical circuits.
If any of those circuits are defective, the engine
trouble warning light will come on, and then the
odometer/tripmeter/clock display will indicate a
two-digit error code (e.g., 12, 13, 14).
This model is also equipped with a self-diagno-
sis device for the immobilizer system.
If any of the immobilizer system circuits are
defective, the immobilizer system indicator
light will flash, and then the right display will
indicate a two-digit error code.
ECA5S71001
If the display indicates an error code, the
vehicle should be checked as soon as pos-
sible in order to avoid engine damage.
Brightness control mode
1. Brightness level
This function allows you to adjust the bright-
ness of the multi-function meter unit panel to
suit the outside lighting conditions.
To set the brightness:
1. Turn the key to "OFF".
2. Push and hold the "SELECT" switch.
3. Turn the key to "ON", and then release the
"SELECT" switch after five seconds.
4. Adjust the multi-function meter unit panel
brightness level by pushing the "SELECT"
switch.
5. Push the "RESET" switch.
The odometer/tripmeter/clock display will
return to the prior mode.
1-5
FEATURES