Advertisement
Quick Links
Recycling Rowing Boat
Finished projects of OPITEC handicraft kits are not play toy articles in the
same sense as general commercially available ones, but rather are inten-
ded as teaching and learning material supporting educational objectives.
The content of this construction kit may only be built and used by child-
ren and adolescents under the guidance and supervision of qualified
adults. Not suitable for children under 36 months. Risk of suffocation!
Parts List
Birch Plywood
Wooden Strip
Gear Motor
Table Tennis Ball
Wiggly Eyes
Battery Holder with Switch
Tapping Screw
Eyebolt
Rubber Ring
1
Please note:
Quantity
1
1
1
1
2
1
2
1
1
122.072
2x
0,5l
PE Bottle
Philips Screwdri-
ver
Size (mm)
210x150x4
100x20x10
ø40
ø10
2xAA
ø40
Tools Required:
Sandpaper
Fretsaw or
Scroll Saw
Wood Glue
Pricking Awl
(waterproof)
Adhesive Tape
Scissors
ø22
Forstner Drill
Soldering Iron
Description
Base Plate
Paddle/Mounting Head
Drive
Head
Eyes
Power Source
Paddle Attachment
Locking Screw
Mounting Battery Holder
Engineer's File
All Purpose
Glue Superglue
ø2
ø6
Drill
Wire Stripper
Part No.
1
2
3
4
5
6
7
8
9
Advertisement
Related Manuals for Opitec Recycling Rowing Boat
Summary of Contents for Opitec Recycling Rowing Boat
- Page 1 PE Bottle Adhesive Tape Scissors Please note: Finished projects of OPITEC handicraft kits are not play toy articles in the same sense as general commercially available ones, but rather are inten- ø22 ded as teaching and learning material supporting educational objectives.
- Page 2 Building Instruction 122.072 Recycling Rowing Boat Cut out the template (page 5) and fix it with adhesive tape on the plywood panel (1). Saw out the individual parts and clean all saw cuts with sandpa- per. ø2 ø6 Transfer the dimensions for the paddle arm parts (2a, 2b) and the head mounting (2c) to the wooden strip (2). Then cut to length and clean the saw cuts.
- Page 3 Building Instruction 122.072 Recycling Rowing Boat Place the geared motor (3) in the hole as shown so that it rests with Screw the ring notch (8) into the hole provided as shown. the body on the base plate. Note: cable connections are on the right in the direction of travel! Glue the two wooden parts (1e) as shown on the upper side in front of Glue the head mounting bracket (2c) onto the geared motor as shown.
- Page 4 Building Instruction 122.072 Recycling Rowing Boat Detail Feed the cables of the battery holder down through the hole in the Glue the table tennis ball (4) centred on the head mounting. Then glue base plate (1a). Solder the connection as shown in detail. After che- the two wiggly eyes (5) onto the head.
- Page 5 Building Instruction 122.072 Recycling Rowing Boat Template Base Plate M 1:1...
Need help?
Do you have a question about the Recycling Rowing Boat and is the answer not in the manual?
Questions and answers