Using The Self-Timer - Canon PowerShot S2 IS User Manual

Using the Self-timer

Mode Dial
1
Press
The current setting is displayed.
Pressing the button cycles between
settings.
You can switch between the
(2 sec.) and
the [ (Rec.)] menu (p. 76).
When the self-timer is set to
seconds after the shutter button is pressed fully. With the
specified number of shots are taken after the specified delay.
*May not be displayed, depending on mode.
2
Check that
displayed and shoot the image.
When is selected, the self-timer
sounds and the self-timer lamp starts
blinking when the shutter button is pressed
all the way. The blinking gets faster
approximately 2 seconds before the shutter trips.
When is selected, the self-timer lamp blinks fast from the beginning,
and the shutter trips after approximately 2 seconds.
When is selected and the shutter button is pressed all the way, the
custom self-timer behaves as follows according to the preset delay:
0 seconds:
1 second:
2 to 30 seconds: A beep sounds and the self-timer lamp starts blinking.
You can change the self-timer sound by changing the [Self-Timer Sound]
setting in the [
button.
*
(Custom Timer) options with the [Self timer] option in
, or is
The shutter trips immediately.
A beep sounds and the self-timer lamp blinks fast until
the shutter trips approximately 1 second later.
Approximately 2 seconds before the shot, the self-timer
sounds (if customized), and the blinking gets faster.
(My Camera)] menu (p. 81).
(10 sec.),
( ), the shutter activates 10 (2)
5
option, the
59