Replacing The Date Battery - Canon PowerShot S2 IS User Manual

Replacing the Date Battery

If the Set Date/Time menu appears when you turn on the camera
power, the date battery charge is low and the date and time settings
have been lost. Please replace the battery with a commercially
available lithium coin battery (CR1220) with the following procedures.
Please note that the first date battery may appear to expire relatively quickly
after you purchase the camera. This is because it is installed in the camera
at the point of manufacture, not when you make the purchase.
Warning
Be particularly careful to keep the date batteries out of the reach of
children. Seek medical assistance immediately if a child swallows a battery
since corrosive battery fluids could damage the stomach or intestinal wall.
1
Turn off the power and slide the
battery cover in the direction of the
arrows.
2
Remove the AA-size batteries, then
pull out the battery holder by
hooking your fingertip under the
bottom of the battery holder edge.
3
Remove the old date battery and
place a new date battery into the
date battery holder with the
positive terminal (+) facing
upward.
4
Replace the date battery holder, replace the AA-size
batteries and close the battery cover.
If you ever dispose of your camera, first remove the date
battery for recycling according to the recycling system of your
country.
164
Positive
terminal
(+)
Bij dit produkt zijn batterijen
geleverd. Wanneer deze leeg
zijn, moet u ze niet weggoolen
maar inleveren als KCA