Check Point Smart-1 5050 Installing And Removing page 4

6. Reassemble the appliance.
7. Install a transceiver.
To install a new expansion SAN card on Smart-1 5150 appliances:
1. Prepare the appliance with a shut down, halt and disconnection of power.
2. Install a new expansion SAN card into the riser.
We recommend that you populate the bottom-most slot first.
3. Reassemble the appliance.
4. Install a transceiver.
To replace an existing expansion SAN card on Smart-1 5050
appliances:
1. Prepare the appliance with a shut down, halt and disconnection of power.
2. Remove the riser.
3. Remove the existing expansion SAN card from the riser.
4. Replace the long bracket on the new SAN card with a smaller bracket.
Replacing the Bracket on a SAN Card
See
5. Install a new expansion SAN card into the riser.
6. Install the riser.
7. Reassemble the appliance.
8. Install a transceiver.
To replace an existing expansion SAN card on Smart-1 5150
appliances:
1. Prepare the appliance with a shut down, halt and disconnection of power.
2. Remove the existing expansion SAN card from the riser.
3. Install a new expansion SAN card into the riser.
4. Reassemble the appliance.
5. Install a transceiver.
at the end of the guide.
4