Table of Contents
Advertisement
Memory (under Keyboard) Upgrade Process
5. Turn off the computer, turn it over and remove the battery
keyboard
(page 2 -
13).
6. The memory sockets will be visible at point
7. Gently pull the two release latches (
8. The RAM module
will pop-up, and you can remove it
4
d.
e.
4
6
9. Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.
10. The module's pin alignment will allow it to only fit one way. Make sure the module is seated as far into the slot as it
will go. DO NOT FORCE the module; it should fit without much pressure.
11. Press the module in and down towards the mainboard until the slot levers click into place to secure the module.
12. Replace the bay cover and screws.
13. Restart the computer to allow the BIOS to register the new memory configuration as it starts up.
All manuals and user guides at all-guides.com
(page 2 -
(Figure
11d).
5
) on the sides of the memory socket(s) in the direction indicated below.
6
&
7
(Figure
11f).
f.
5
7
Be careful not to touch the metal pins on the module's connect-
ing edge. Even the cleanest hands have oils which can attract
particles, and degrade the module's performance.
5), component bay cover
(page 2 -
4
Contact Warning
Removing the Primary System Memory (RAM) 2 - 15
Disassembly
Figure 11
9) and
RAM Module
(under keyboard)
Removal
d. The secondary RAM
modules will be visible
at point
.
5
e. Pull the release lat-
ches.
f. Remove the module.
4 RAM Modules
Advertisement
Table of Contents
