Operating Instructions
Circuit Breakers
Two manual reset circuit breakers are located on the
front body. Each has a button that pops out if the
circuit breaker trips. The 10 amp circuit breaker pro-
tects the safety and ignition circuits. The 7 amp pro-
tects the indicator lamps and hourmeter.
Glow Plug Warning Light
The glow plug warning light indicates the glow plug
function is in use.
Battery/Charge Light
The charge light indicates the electric system is not
being charged.
Oil Pressure Warning Light
The oil pressure warning light indicates that engine
oil pressure is below the safe operating level [below
7 PSI (48 kPa)]. This light (and warning horn) will
come on when the ignition is turned ON, but should
go off after the engine is started. If the light fails to
come on when the ignition switch is turned ON, it
would indicate a burned out bulb, or the inline 7 amp
circuit breaker could also be tripped. If the light
comes on during engine operation, stop the engine
immediately and correct the source of the problem
before further engine operation.
IMPORTANT:
with an illuminated oil pressure warning light MAY
cause severe engine damage (if a low oil pressure
condition exists).
Water Temperature Warning Light
The water temperature warning light indicates that
engine coolant temperature is above the safe oper-
ating limit and the engine is overheating. If this
light comes on, there may be a problem with:
•
Radiator cooling air flow (material packed into
radiator cooling fins, clogged air intake screen)
•
Low coolant quantity in cooling system
•
Engine alternator belt
•
Thermostat function
Stop the engine and correct the problem before fur-
ther operation.
IMPORTANT:
with an illuminated water temperature warning light
MAY result in severe engine damage.
Battery/Charge
Glow Plug
Warning Light
Circuit
Breakers
Oil Pressure
Warning Light
Engine Warning Lights
Continued operation of the engine
Continued operation of the engine
Light
Water Temperature
Warning Light
29