Stopping The Machine - Walker MBSY Operator's Manual

Operating Instructions
Blade Clutch Disengaged
If the cutting blades strike a stationary ob-
ject while mowing, stop the mower im-
mediately, disconnect the electrical plug
on the fuel shut-off solenoid, lift the deck,
and inspect the deck and blades thor-
oughly for damage. Also, make sure the
blade retaining bolts are torqued to
64 ft-lb (87 N

STOPPING THE MACHINE

1. Pull the steering levers to the NEUTRAL-PARK
position and then move the FSC lever backward
to the NEUTRAL-PARK position.
2. Slow the engine to idle; put the throttle in the
IDLE position.
3. Disengage the blade clutch.
IMPORTANT: DO NOT disengage the blade
clutch with high engine speed (above 1/2 throttle)
since the brake action on the blade drive will
cause increased wear of the brake band.
36
CAUTION
·
m).
WARNING
A brake stops the cutter blades from free-
wheeling within five (5) seconds after dis-
engaging the clutch. If the brake system
malfunctions and the blades do not stop
within five (5) seconds, the brake should
be repaired or replaced before operating
the mower. Contact your Walker dealer.
4. Turn the ignition switch OFF.
WARNING
Remove the key from the ignition switch
when leaving the mower unattended. This
will prevent children and inexperienced
operators from starting the engine.
5. Engage the parking brake. Also, engaging the
parking brake is recommended when stopping
or parking the machine in a confined space with
little tolerance for movement.
IMPORTANT: The transaxles lock to prevent the
mower from rolling freely with the engine stopped.
However, if the mower is parked on a slope, it is
necessary to ENGAGE the parking BRAKE to
prevent the mower from creeping. This is due to
a small amount of slippage in the transaxles, es-
pecially when transmission fluid is warm.
WARNING
In case the transmission drive belt breaks
during operation, and if the machine is on
a slope, the machine will freewheel down
the slope. To maintain control, immediately
(1) Release the steering levers and
simultaneously (2) Move the FSC to the
NEUTRAL-PARK position.
machine is stopped or moving slowly,
engage the parking brake.
NOTE: The emergency stop procedure is exactly
the same procedure as used to normally stop and
park the machine.
When the