Table of Contents
Advertisement
Safety Instructions
SAFETY, CONTROL, AND INSTRUCTION DECALS
Safety, Control, and Instruction Decals are installed on the machine;
if any are missing, illegible, or damaged, a replacement should be ordered and installed before
putting the machine into operation. The Decal Part Number is listed below and in the Parts Manual.
N
Location: Right Fender
Part Number: 2802-4
1.
Warning – do not operate the machine without a
deck or other implement attached.
2.
Forward Speed Control
•
Move lever forward to increase speed; back
to stop.
3.
Body Tilt Latch
•
Raise lever to release.
•
Lift at back of body to raise.
4.
Warning – do not engage PTO clutch with PTO
shaft disconnected.
5.
PTO Clutch Lever
•
Move lever forward to engage PTO clutch;
back to disengage.
1.
2.
3.
4.
5
2802-4
Location: ROPS Roll Bar (Optional)
Part Number: 5685-3
1.
Warning – roll-over/crushing hazard
•
Do not operate the machine on steep slopes
or near drop-offs.
•
Avoid quick and/or sharp turns when operat-
ing on slopes.
2.
During normal operation always keep the ROPS
locked fully upright and use the seat belt.
3.
Never use the seat belt if the ROPS is not locked
fully upright.
4.
Do not operate the machine on slopes if the
ROPS is not locked fully upright.
5.
Do not remove the ROPS.
1.
2.
3.
4.
5.
5685-3
17
Advertisement
Table of Contents
