Maintenance Instructions
Blade Clutch (PTO)
Clutch Engagement/Belt Tension
The clutch engagement and PTO belt tension are
adjusted using the clutch link. Initially, after install-
ing new PTO belts, after 10 hours and every 100
hours thereafter, check and adjust for the dimen-
sions as shown in the PTO Clutch Engaged and
PTO Clutch Disengaged illustrations.
Clutch Link
Ball Joint
Spring
Compressed
72
Adjust the length of the clutch link to achieve a bolt
head clearance of 1/4 in. to 5/16 in. (6.35 mm to
7.94 mm) with the clutch engaged. To adjust length:
remove ball joint from clutch arm, shorten the clutch
link to increase this measurement or lengthen the
clutch link to decrease this measurement. If adjust-
ments are needed more frequently than every 100
hours to maintain dimensions, it may suggest prob-
lems with pulley wear or belt misalignment.
1/4 in. to 5/16 in.
(6.35 mm to 7.94 mm)
Clutch Engagement
Arm
Clutch Arm
Front of Mower
PTO Clutch Engaged
ADJUSTMENTS
Blade Clutch
Engaged
Blade Clutch
Idler Pulley