Ignition Switch; Light Switch (For Optional Lights); Warning Horn; Circuit Breakers - Walker T23 Operator's Manual

Operating Instructions

Ignition Switch

The ignition switch is used to start and stop the en-
gine. The switch has three positions: "O" is the OFF
position, "I" is the ON (RUN) position that the key
returns to after starting, and
tion. When starting the engine, turn the key clock-
wise to the START position. Do not hold the key in
the START position longer than 10 seconds. If the
engine does not start, return the key to the "O" posi-
tion for at least 60 seconds before making a restart
attempt. Prolonged cranking can damage the start-
er motor and shorten battery life. Release the key
when the engine starts, and it will return to the ON
(RUN) position. To stop the engine, rotate the key
counterclockwise to the "O" position.
OFF
Ignition Switch

Light Switch (For Optional Lights)

Operates headlights (when installed).

Warning Horn

The warning horn sounds to alert the operator that
an unsafe engine condition is being indicated -
when engine temperature is too high or engine oil
pressure is too low. If the horn sounds, check the
indicator lights and correct the problem before fur-
ther operation.
is the START posi-
ON (RUN)
START

Circuit Breakers

One manual reset 7 amp circuit breaker that pro-
tects the safety circuits and GHS is located on the
instrument panel. A button pops out if the circuit
breaker trips. An auto reset 30 amp master circuit
breaker is located near the battery.

STARTING THE ENGINE

CAUTION
Before operating the mower, read and un-
derstand all Safety Instructions and Operat­
ing Instructions.
WARNING
NEVER run the engine in an enclosed or
poorly ventilated area.
contains carbon monoxide, an odorless
and deadly gas.
1. Before attempting to start the engine, make
sure the operator is in the seat, the Forward
Speed Control is in NEUTRAL-PARK position,
and the blade clutch and parking brake are DIS-
ENGAGED.
NOTE: Release parking brake to prevent extra
load on the starter if the transmission neutral is
slightly out of adjustment.
CAUTION
A safety interlock switch system PRE-
VENTS CRANKING the engine with either
the Forward Speed Control out of neutral,
or the blade clutch (PTO) engaged. If the
engine cranks otherwise, the safety sys-
tem is not working and should be repaired
or ad justed before operating the mower.
DO NOT disconnect safety switches; they
are for the operator's protection.
Engine exhaust
33