Running Belt Replacement; Adjusting The Running Belt - Matrix TF30 Service Manual

3.6 RUNN NING BELT
1) Remove the motor co
2) Remove the rear rolle
3) Remove the running
4) Remove the front roll
5) Remove the running
5) Reverse e Steps 1-5 t
Note1:
1. Adj just running
2. The e running dec
matche d to a new ru
:
Note:2
ADJUSTING G THE RUN
After plac cing the tread
centering. T The belt may
cause the b belt to stretch
direction be elow.
Step1: Loca ate the two h
frame at the e back of trea
Step2: Th ere should b
the belt is to ouching one
Manually ce enter the belt
as they wer re loosened.
Step3: Whil e the treadm
Right bolt by y turning it cl
left tighten t the left bolt b
remains cen ntered for se
Step4: Chec ck the tensio
should not h hesitate or sl
necessary.
CH HAPTER 3
T REPLAC CEMENT
over as outlin ned in Sectio
er as outlined d in Section 3
deck as outl ined in Secti
er as outline ed in Section
belt
Fig-1
to install a ru unning belt.
belt tension after replace
ck is silicon o on one side o
unning belt a and Only T70
NING BELT
dmill in the p osition it will
need to be a adjusted afte
h at different rates. If the
ex head bolt t on the rear
admill. These e bolts adjus
be an equal a amount of sp
side, turn the e bolts count
t by pushing the belt towa
mill is running g at 3 mph, o
lockwise 1/4 turns, and lo
by turning it c lockwise 1/4
everal minute es.
on of the belt . The belt sh
lip. If this occ curs, tighten
3: Part Re eplacemen
on 3.1.
3.2.
on 3.4.
3.5.( Fig-2)
ement (Note2 2 )
onTF30/TF5 50/TF50-2. N
0-02 models is waxed de
be used, the e belt must b
er the first 2 h hours of use
belt starts to o slip when a
of the treadm mill. The bolt
st the rear rol ller.
pace on eithe er side of the
ter clockwise e approximat
ard the cente er. Tighten
observe the b belt position.
oosen the lef ft bolt 1/4 turn
4 turn and loo osen the righ
hould be very y snug. When
the belt by t urning both b
nt Guide
Fig-2 2
ew deck surf rfaces must A
ck only 1 sid de
be checked fo or proper ten
. Temperatur re and humid
user is on it , be sure to f
ts are located d at each en
running belt t and the sid
tely one full t turn on each
the bolts the e same amou
If it is movin ng to the righ
n. If it is mov ving to the lef
t 1/4 turn. Re epeat step 3
n a person w walks or run o
bolts clockwi ise 1/4 turn,
ALWAYS be
nsion and
dity, and use e
follow the
d of the
e rails. If
side.
unt of turns
t, tighten the e
ft, tighten the e
until the belt t
on the belt, it t
Repeat if
23 3