Setting This Stand - Sony RHT-G15 Operating Instructions Manual

Setting this stand

About the installation position
Install the stand after connecting all the
components to the stand.
Install the stand after allowing for a space of
more than 1 cm from the wall. This is to allow
for heat dissipation and to prevent the TV from
falling. Installation of the stand requires two or
more people.
Note
• Be careful not to pinch your fingers when setting up
the stand.
Preventing the TV from falling
Secure the TV to provide a protective measure
against earthquakes, etc.
Perform the following steps if you have a Sony
LCD TV.
1
Take off the top cover and the side
cover from the rear side of the stand.
When you take off the top cover, hold both
ends of the cover as shown in the illustration
and slowly take it off.
When you take off the side cover, hold the
side and bottom of the cover as shown in the
illustration and slowly take it off.
8
GB
More than
2
1 cm
Place the TV on the stand.
The TV should be placed in the center of the
stand, aligning the rear edge of the TV's
base with the stand's rear edge.
3
Fasten the support belt to the stand
with a wood screw.
You can fasten a wood screw to the
centrally-positioned hole on the rear of the
stand.
For details on acquiring the support belt and
screws, refer to the operating instructions
supplied with Sony LCD TV.
Top cover
Hole for a wood screw
Side cover