Assembling The Table-Top Stand - Sony SU-PT3M Manual

Assembling the Table-
Top Stand
WARNING
If you allow the mains lead to be pinched under or
between pieces of equipment, this may result in a
short circuit or an electric shock.
If you stumble over the mains lead or the
connecting cable, the stand may topple over and
cause injury.
Decide on the installation location and work
near there.
Since the TV is heavy, it is recommended that you
decide on the installation location and lay the
Table-Top Stand down before installing the TV.
Note
Do not drag the Table-Top Stand. The rubber footings on
the base of the Table-Top Stand may come off.
1
Change the position of the
woofer speaker.
1 Loosen the screws (two each on the left and
right pillars) used to secure the woofer
speaker in place (about three turns).
2 Slide the woofer speaker as shown in the
illustration until it stops.
3 Tighten the screws loosened in Step 1 at the
position indicated by the f mark to secure
the woofer speaker.
Screw position before sliding. (Loosen the
screws, but do not remove them.)
Screw position after sliding.
(f mark)
3
2
Note
If you fail to slide the woofer speaker completely in
Step 2, you cannot secure the screws in Step 3.
1
Soft cloth
2
Secure the rear panel to the
bottom plate.
1 Place the rear panel on the bottom plate so
that the projections on both ends of the metal
part of the bottom plate fit into the slots on
the base of the rear panel.
2 Tighten the four rear panel securing screws
using the supplied hexagonal wrench to
secure the rear panel to the bottom plate.
Rear side
Hexagonal socket
screw with washer
Front side
Hexagonal socket
countersunk screw
5