The HDMI CONTROL function will not operate in the following cases: • When you connect this stand to a component which is not correspond with Sony’s HDMI CONTROL function. • When you connect the stand and components using other than HDMI connection.
Page 3
A Optical cable (supplied) Make this connection to listen to the high quality sound of the TV. B HDMI cable (not supplied) We recommend that you use a Sony HDMI cable. Note • We recommend that you do not use components...
Page 4
Preparing for the HDMI CONTROL functions Before you use the HDMI CONTROL function, be sure you have performed the following procedures. For details on setting the TV and connected component, see the operating instructions of them. Input buttons (DVD/BD, SAT) Make sure that the stand is connected to the TV and connected component (which should be compatible with the...
Watching a DVD (One-Touch Play) Play back a connected component. The stand and the TV are turned on automatically and switch to the appropriate HDMI input. Note • Depending on the TV, the start of the content may not be output. •...
Page 6
Using the input buttons of the remote of the stand The input buttons (TV (white), DVD/BD, SAT, AUDIO) work as follows when the HDMI CONTROL is set to “ON.” • DVD/BD, SAT: Since the input of the TV is also switched automatically, you can watch the image of the selected component on the TV simply by pressing the buttons.
Troubleshooting If you experience any of the following difficulties while using the HDMI CONTROL function, use this troubleshooting guide to help you remedy the problem. The HDMI CONTROL function does not work. • Check the HDMI connection (page 3). • Make sure “HDMI CTRL” is set to “CTRL ON”...