Setting This Stand - Sony RHT-G5 Operating Instructions Manual

Setting this stand

Assembling the stand
The stand requires assembly. For details, refer to
"Theatre Stand System Installation Guide"
(supplied).
About the installation position
Install the stand after connecting all the
components to the stand.
Install the stand after allowing for a space of
more than 7 cm from the wall. This is to allow
for heat dissipation and to prevent the TV from
falling. Installation of the stand requires two or
more people.
Side view
Note
• Be careful not to pinch your fingers when setting up
the stand.
Preventing the TV from falling
Secure the TV to provide a protective measure
against earthquakes, etc.
Perform the following steps if you have a Sony
LCD TV.
1
Place the TV on the stand.
The TV should be placed in the center of the
stand, aligning the rear edge of the TV's
base with the stand's rear edge.
8
GB
2
More than
7 cm
Fasten the support belt to the stand
with a wood screw.
You can fasten a wood screw to the
centrally-positioned hole on the rear of the
stand.
For details on acquiring the support belt and
screws, refer to the operating instructions
supplied with Sony LCD TV.
Hole for a wood screw