6: Preparing The Receiver And The Remote - Sony STR-DN1000 Operating Instructions Manual

6: Preparing the receiver
and the remote
Setting the voltage selector
(Models of area code E51 only)
If your receiver has a voltage selector on the
rear panel, check that the voltage selector is set
to the local power supply voltage. If not, use a
screwdriver to set the selector to the correct
position before connecting the AC power cord
(mains lead) to a wall outlet.
Depending on the models of area code, the
VOLTAGE SELECTOR may differ.
VOLTAGE SELECTOR
240V 220V
Connecting the AC power cord
(mains lead)
Connect the AC power cord (mains lead) to a
wall outlet.
AC power cord (mains lead)
OUT
L
L
120V
To the wall outlet
Notes
• Before connecting the AC power cord (mains
lead), make sure that metallic wires of the speaker
cords are not touching each other between the
SPEAKERS terminals.
• Connect the AC power cord (mains lead) firmly.
Performing initial setup
operations
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
Be sure to use the buttons on the receiver for
this operation.
?/1
MULTI CHANNEL DECODING
?/1
1
Press ?/1 to turn off the
receiver.
2
Hold down ?/1 for 5 seconds.
After "CLEARING" appears on the
display for a while, "CLEARED!"
appears.
All the settings you have changed or
adjusted are reset to the initial settings.
MASTER VOLUME
INPUT SELECTOR
MUTING
35 GB