enphase IQ 7+ Installation And Operation Manual page 34

Topic
6
Maximum microinverters per 20A (max) AC branch circuit
240 VAC (single phase)
208 VAC (single phase)
CEC weighted efficiency
240 VAC (single phase)
208 VAC (single phase)
Static MPPT efficiency (weighted, ref EN 50530)
Total harmonic distortion
Ambient temperature range
Night tare loss
Storage temperature range
Compatibility
Dimensions not including mounting bracket
Connector type
Weight
Environmental category / UV exposure rating
Torque specifications for fasteners
(Do not over torque)
Cooling
Relative humidity range
Approved for wet locations
Pollution degree
Communication
Standard warranty term
Compliance
Grounding
Monitoring
Integrated DC disconnect/
Integrated AC disconnect
6
Limits may vary. Refer to local requirements to define the number of microinverters per branch in your area.
.
34
IQ 7 / IQ 7+ / IQ 7X / IQ 7A Micro Installation and Operation
IQ7PLUS-72-2-US Microinverter Parameters
Miscellaneous Parameters
Features and Specifications
Pairs with most 60-cell/120- half-cell and 72-cell/144 half-cell
PV modules
212 mm x 175 mm x 30.2 mm (approximate)
MC-4 connector
1.08 kg (2.38 lbs.)
NEMA type 6 / outdoor
•
•
•
Natural convection - no fans
4% to 100% condensing
Yes
PD3
Power line communication (PLC)
enphase.com/warranty
CA Rule 21 (UL 1741-SA) UL 62109-1, UL1741/IEEE1547, FCC
Part 15 Class B, ICES-0003 Class B, CAN/CSA-C22.2 NO. 107.1-
01. This product is UL Listed as PV Rapid Shut Down Equipment
and conforms with NEC-2014 and NEC-2017 section 690.12 and
C22.1-2015 Rule 64-218 Rapid Shutdown of PV Systems, for AC
and DC conductors, when installed according manufacturer's
instructions.
The DC circuit meets the requirements for ungrounded PV
arrays in NEC. Ground fault protection (GFP) is integrated into
the class II double insulated microinverter.
Enlighten Manager and MyEnlighten monitoring options. Both
options require an Enphase IQ Envoy
The DC and AC connectors have been evaluated and
approved for use as the load-break disconnect required by
NEC 690.
© 2020 Enphase Energy Inc. All rights reserved.
Unit Min
%
97.0
96.5
% 99.0
%
C
-40
mW
C
-40
6 mm (1/4") mounting hardware: 5 N m (45 - 50 in-lbs.)
8 mm (5/16") mounting hardware: 9 N m (80 - 85 in-lbs.)
When using UL 2703 mounting hardware, use the
manufacturer's recommended torque value
Typical Max
13
11
5
+65
50
+85
141-00043-03