Resetting The Target - Analog Devices ICE-100B User Manual

Resetting the Target

Figure 2-1. LED Positions - Top of Emulator Board
Resetting the Target
When debugging remotely, the ability to reset the target can be very use-
ful. Enable this function through the Reset Target Options dialog box
and by soldering a wire from the ICE-100B emulator to the target. Two
solder points labeled "RESET" (reference designator P3) are located near
the JTAG connector (J1) and the USB connector (P1) on the ICE-100B.
For an active low version (~RESET), solder a wire between the square pad
(pin 1) of P3 and the ~RESET input signal of the target.
For an active high version (RESET), solder a wire between the round pad
(pin 2) and the RESET input signal of the target

If the Enabled option of the Reset Target Options dialog box is
not selected (checked), the Reset Target command under the
Debug menu item will be grayed out.
2-2
PN: ADZS-ICE-100B
a
ICE-100B
STAT
LED3
ICE-100B Emulator User Guide
PWR
LED1
LED2