Table of Contents
Advertisement
USB Installation Tasks
Table 1-2. JP2 Settings
Jumper
Uninstalled
Installed
4. Connect the USB cable between the ICE-100B emulator and a
USB port of your computer.
5. Verify driver installation. Refer to
on page
Before connecting to a target, see the power-up/down procedures
in
"Attaching to the Emulation Target" on page
Verifying Driver Installation
Before using the ICE-100B emulator, verify that the driver software is
installed properly.
Open the Windows Device Manager and verify that the ICE-100B
emulator appears under ADI Development Tools, as shown in
1-4
Operating System
Windows
Linux
1-4.
"Verifying Driver Installation"
1-6.
ICE-100B Emulator User Guide
Figure 1-2
Advertisement
Table of Contents
Need help?
Do you have a question about the ICE-100B and is the answer not in the manual?
Questions and answers