Combination Wood-Electric Or Wood-Oil Furnace - CADDY PF01015 Installation And Operating Instructions Manual

Once wired to the furnace, it is possible to check the signals from the wall thermostat. On the touch screen main menu,
select "TROUBLESHOOT LINK" on page 1 as shown below. When a signal is sent from the thermostat, the circle
corresponding to the signal should appear green.

15.1.1. COMBINATION WOOD-ELECTRIC OR WOOD-OIL FURNACE

Only one thermostat is necessary to control the wood furnace and any other auxiliary heating source. Installing the
thermostat is done the same way as if the furnace was wood only. See Section 16.4.1 - TRANSITION TO AN
AUXILIARY HEAT SOURCE to learn how to make it work.
It is also possible to use 2 thermostats (one for wood, one for alternate heat), go in parameters (gear button), then
press on SETUP, OPTIONS, INSTALL TYPE, 2ND THERMOSTAT. Note that the 2 thermostats mode will not work
if the heat pump option is selected.
The 2 nd thermostat shall be wired as per this wiring diagram:
45