Removal Of Ironed Laundry; Pausing Ironing; Standby Mode; Flexcontrol" Footswitch - Miele PRI 210 Operating Instructions Manual

Removal of ironed
laundry

Pausing ironing

Standby mode

"FlexControl"
footswitch
Stopping the roller
Do not feed small items into the iron on only one side.
If laundry is fed in on just one side, the heat will only be used on
one side and the load only exerted on the roller padding on one
side. If in-feed of laundry continues to be on one side only, this will
be indicated by an audible signal sounding and the red  symbol
or  symbol appearing in the display.
Use the entire roller width wherever possible and distribute small
items evenly on the laundry in-feed table.
The picker springs on the laundry picker band separate the ironed
laundry from the roller. The laundry can then be removed from the ro-
tary iron.
 Risk of burning due to hot edges of the heater plate outfeed.
While the rotary iron is in use, the heater plate gets very hot. Ironed
laundry can be very hot when it comes out of the heater plate.
Always take care when removing ironed laundry.
Do not touch the edges of the heater plate outfeed.
If a picker spring comes loose from its position, the rotary iron must
be switched off. The picker spring then needs to be moved back to
the original position of the laundry picker band by hand.
 Risk of fire due to laundry self-combustion.
Hot laundry can lead to a fire as a result of self-combustion.
It is important that you let ironed laundry cool down sufficiently be-
fore packing or stacking it.
Press the  button to interrupt the ironing process and switch the

rotary iron to pause mode.
In Pause mode, the roller stops and the heater plate disengages. The
rotary iron's heater will initially remain switched on. During pause
mode, the rotary iron remains ready for use.
Press the  button to start ironing again.

After an adjustable period of non-use, the rotary iron can switch to
standby mode. In Standby mode, the roller comes to a standstill and
the heater plate is disengaged. During this process, the rotary iron's
heater is switched off as well.
Press the  button to switch the rotary iron back on.
Standby mode is deactivated by default. Standby mode can be acti-
vated at service level by Miele Technical Service. The time at which
the rotary iron will switch to standby mode can be adjusted to a
value between 1 and 30 minutes of non-use.
Activating the moveable footswitch stops the roller. This makes it
easy to avoid mistakes when feeding in items.
During ironing, press down the footswitch with your foot.

Use
19