Advertisement
3. L
OADING THE
Gently pop the printer cover's latch to open the cover (Figure 9); then lift the cover. Load a roll of thermal paper
(Appleton 1012 recommended) into the printer (Figure10). Load it so that the print-side of the paper will feed out
facing the operator. Close the cover by pressing down evenly on both side tabs, or by pressing on the center of the
printer cover. Use the serrated bar to tear off any excess paper.
4. U
M
SING THE
Magnetic Card Reader
Find the card reader slot at the right side of terminal. Slide the card in either direction through the slot without
stopping. If the card swipe fails, check the position of the magnetic stripe and slide the card again (Figure 11).
5. U
K
SING THE
To enter numbers or letters, simply press the appropriate key. For example, to type the letter B: Press and release [B]
twice times, then display shows B (Figure 12).
6. I
NSTALLING THE
There are four SAM slots located on the left side of the device (Figure 13). Before insert the SAM card, please turn off
the device. Insert the SAM card in the slot in figure 16. Make sure SAM cards inserted in the right direction (Figure
14).
P
APER
Figure 9
C
AGNETIC
ARD
P
EY
AD
SAM
CARD
Figure 13
R
EADER
Figure 11
Figure 12
Figure 10
Figure 14
Advertisement
