lopital Nemo Cleaning And Disinfection Protocol page 31

Cleaning protocol
1. Before cleaning and disinfecting, unplug the product if applicable.
Cleaning
2. Clean the trolley with a damp cloth with warm water and an institution-approved neutral
detergent. A soft brush can be used to remove stains and stubborn dirt.
3. Wipe the entire trolley from top to bottom. Do not use a dripping wet cloth. For easy access to all
parts of the trolley, adjust the trolley to both the highest and lowest position.
4. Pay extra attention to the following surfaces:
Mattress
-
Pillow
-
Stretcher board
-
Side rails
-
Head and foot ends
-
Manual operation (with electrically powered trolley)
-
Foot pedal (with hydraulic powered trolley)
-
Brake pedals
-
On/off switch (with electrically powered trolley)
-
Emergency lowering button and emergency stop (with electrically powered trolley)
-
Lever Anti-trendelenburg position
-
Wheels
-
You can also use a cleaning unit/cleaning system to clean your trolley. The temperature in the system
should be a maximum of 55°C.
Disinfecting
5. Repeat the cleaning protocol - Cleaning after reading "Applying common cleaning/disinfectants to
Lopital products" on page 3 of this document. Follow the manufacturer's directions for proper use
of the disinfectant.
6. After disinfecting the trolley, wipe the trolley with a damp cloth and clean water to remove any
residue from the disinfectant.
30 | Cleaning and disinfection protocol