Complete Installation; Air Conditioner Use - Hisense AW1221DR3W Use And Installation Instructions

Install Air Conditioner into Cabinet and Install Front Panel to Unit
1. Lift air conditioner and carefully slide into cabinet.
.
2 CAUTION: Do not push on controls OR finned coils.
.
3 Be sure air conditioner is firmly seated towards rear of cabinet.
4. Reconnect electronics plug if present. Position vent control lever so that it will thread into its channel
in the front panel.Hook front panel top tabs into slot on cabinet top, and rotate front panel down so that
side tabs snap into place on cabinet. Insert 4 previously removed screws through front panel and into
air conditioner.
.
5 Insert air conditioner filter. Reinstall the front grille by hooking bottom tabs into slots on Front Panel
bottom, then rotating grille up to snap into place.
1. Plug into a grounded 3 prong outlet.
2. Press RESET on the power supply cord. See "Electrical
Requirements".
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
If you turn off the air conditioner, wait at least
■
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
s

Complete Installation

Plug into a grounded
Do not remove ground prong .
Do not use an adapter .
Do not use an extension cord .
Failure to follow these instructions can result in death ,
fire or electrical shock

AIR CONDITIONER USE

■
■
3
minutes
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
10
Vent control
correct location
Electrical Shock Hazard
WARNING
3
prong outlet
, .
Air conditioner in the Cool mode operation the better limits:
Outdoor side 64.4~109.4°F (18~43 °C), ≤80%RH; indoor side
62.6~89.6°F (17~32°C), ≤80%RH.
Air conditioner in the Heat mode operation the better limits:
Outdoor side 19.4~75.2°F (-7~24 °C), ≤80%RH; indoor side
32~80.6°F (0~27°C), ≤80%RH.
.