Complete Installation; Air Conditioner Use - Hisense AW0621CR1W Use And Installation Instructions

Remark a line on the EVA Foam
(3mm) than the measured width in, then cut the EVA
Foam along the line.
1. Insert foam seal behind the top of the lower window sash and
against the glass of the upper window.
A
2. Use a
1 /8" (3mm) drill bit to drill a starter hole through the
hole in the top rail.
3. Attach top channel to window sash with one
screw to secure window in place.
M
The M.Sealing sponge is provide for 6K DOE cooling only
4. Check the gap around the unit and seal it with the adhesive
seal attached.
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
If you turn off the air conditioner, wait at least
■
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
according to less 1/8

Complete Installation

B
A. T op of lower window sash
.
B Foam seal
(19mm)
3/4"
check the gap

AIR CONDITIONER USE

3
minutes
Remove the backing from the EVA Foam.
Attach one EVA Foam on the Curtain housing
with adhesive should facing the
A
B
NOTE: The EVA Foam is not need to attach for Models:
cooling only.
6K regular
5. Repeat for the right-hand curtain.
Plug into a grounded
Do not remove ground prong .
Do not use an adapter .
Do not use an extension cord .
Failure to follow these instructions can result in death ,
,
fire or electrical shock
5. Plug into a grounded 3 prong outlet.
6. Press RESET on the power supply cord. See "Electrical
Requirements".
A ir conditioner in the Cool mode
■
Outdoor side 64.4~109.4°F (18~43 °C), ≤80%RH; indoor side
62.6~89.6°F (17~32°C), ≤80%RH.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
8
Curtain housing
A
A. Curtain housing
B. EVA Foam
Electrical Shock Hazard
WARNING
3 .
prong outlet
.
operation the better limits:
, the side
.
B