Advertisement
Page 6 of 6
SIE BENÖTIGEN FOLGENDES WERKZEUG
MONTAGEANLEITUNG
•
Die Schraube durch den Rahmeneinsatz führen, sodass der Schraubenkopf in die Senkbohrung
passt.
•
Den Expander am hervorstehenden Ende der Schraube anbringen, sodass sie in die flache Fläche
in die Vertiefung des Rahmeneinsatzes passt.
•
Die Spezialmutter am hervorstehenden Ende der Schraube anbringen, sodass sie in den Expander
rein geht.
•
Die Schraube festziehen bis die Mutter den Expander leicht berührt.
•
Die Einheit in der Rahmenvertiefung positionieren wie oben abgebildet.
•
Die schrauben festziehen, so dass der Rahmeneinsatz sicher in Position befestigt ist (nicht zu fest
ziehen).
•
Einen Bubble-Aufkleber vom Kit in die Vertiefung einsetzen, um den Schraubenkopf abzudecken.
•
Überprüfen Sie regelmäßig, dass der Rahmeneinsatz fest fixiert ist.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes which do not diminish their performance
or visual appeal and supplying them in such state shall conform to the order. The Buyer acknowledges no representation or warranty (other than as to title) has been given or will
apply to the Products other than those in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality and suitable for its
particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care and rectify any fault free of charge unless the
workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any
defective Products R&G shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have been modified or used or
maintained otherwise than in accordance with R&G's or manufacturer's instructions and good engineering practice or if the defect arises from accident or neglect. Other than
identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be liable for indirect or consequential loss and otherwise its liability
shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were purchased direct from us (customer must
prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable condition, in the opinion of R&G Racing. All returns are subject to a 25% restocking
and handling fee (25% of the gross value exc. P&P – at the prevailing price at time of purchase). The customer must pay any and all carriage charges. No returns of discontinued
products, unless within 14 days of purchase. This policy does not affect your statutory rights and does not refer to faulty goods.
Unit 1, Shelleys Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0) 1420 89007 | Fax : +44 (0) 1420 87301 | Email: info@rg-racing.com
•
3mm Inbusschlüssel
Ausgabe 1 10/01/2018
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
R&G Racing
(LF)
FI0152BK
Advertisement
