Table of Contents
Advertisement
The R-Tech PLASMA 50HF is a member of our field acclaimed family of welding products. Premium features
include:
1. Inverter power source - more efficient to operate, provides smoother weld characteristics.
2. Infinite cutting power adjustment, allows fine tuning of cut characteristics
3. HF Pilot start - Enables easy arc start even on painted surfaces
4. HF pilot arc restart - ideal for cutting mesh etc
5. Digital amp meter
6. Quick fitting torch for easy torch fitment/replacement
7. Long life -Low cost torch consumables
8. 60% Duty cycle at 50 Amps @ 40
Recommended Processes
The R-Tech PLASMA 50HF is recommended for the plasma cutting processes within its output capacity of 50
Amps DC
Equipment Limitations
The R-Tech PLASMA 50HF is protected from overloads beyond the output ratings and duty cycle as per machine
specifications with thermostat protection of the output coils and rectifiers and is rated at 50 Amps at 60% duty cycle
on a ten minute basis. If the duty cycle is exceeded a thermal protector will shut machine off until the machine cools.
Power Voltage
Rated Output Current
Current Adjusting Range
No-load Voltage
Rated Duty Cycle
Max. Cutting Thickness (Clean cut mild steel)
Max. Cutting Thickness (Severance cut mild steel)
After Flow Time
Introduction
O
C
Technical Specifications
MODEL
Fuse rating
Starting Mode
Air Pressure
Dimensions
PLASMA 50HF
220/240V 50/60Hz
32Amps
50A
20-50A
200V
60%
HF Pilot Arc Start
75 PSI
18mm
24mm
10 Seconds
390 X 190 X 290
4
Advertisement
Table of Contents
