Technical Specifications - R-Tech PLASMA 40HF Operation Instructions Manual

The R-Tech Plasma 40HF is a member of our field acclaimed family of welding products.
Premium features include:-
1. Inverter power source – more efficient to operate, provides smoother weld
characteristics.
2. Infinite cutting power adjustment, allows fine tuning of cut characteristics
3. HF Pilot start – Enables easy arc start even on painted surfaces
4. HF pilot arc restart – ideal for cutting mesh etc
5. Digital amp meters
6. Quick fitting torch for easy torch fitment/replacement
7. Long life – Low cost torch consumables
8. 60% Duty cycle at 40 Amps @ 40
Recommended Processes
The R-Tech Plasma 40HF is recommended for the plasma cutting processes within its output
capacity of 40 Amps DC
Equipment Limitations
The R-Tech Plasma 40HF is protected from overloads beyond the output ratings and duty cycle
as per machine specifications with thermostat protection of the output coils and rectifiers.
Cutting Capability – Duty Cycle
The R-Tech Plasma 40HF is rated at 40 Amps at 60% duty cycle on a ten minute basis. If the
duty cycle is exceeded a thermal protector will shut machine off until the machine cools.
MODEL
Power Voltage
Input Current
Rated Output Current
Current Adjusting Range
No-load Voltage
Rated Duty Cycle
Working Mode
Air Pressure
Max. Cutting Thickness (Clean cut mild steel)
Max. Cutting Thickness (Severance cut mild steel)
After Flow Time
Dimensions
4
Introduction
º
C

Technical Specifications

PLASMA 40HF
220/240V 50/60Hz
28A
40A
20-40A
200V
60%
HF Start
50 PSI
12mm
16mm
10 Seconds
390 X 190 X 290