Interaction Setting - Qomo HiteVision QRF 500 User Manual

Audience response system
Table of Contents

Advertisement

play button to start a quiz. When the timer reaches 0, students are unable to send their answer. The
instructor can advance to the next question and start the quiz.
The Timer enabled and run automatically question by question setting allows you to select
timers for each question. The preset times for each question will count down when the quiz begins.
When the time is up, the next question will be shown automatically and the new preset time for the
question is displayed. This will repeat until all of the questions in the exam have been completed,, or
the instructor presses the pause or stop button to interrupt the quiz.
Note: This function is unavailable under free-style mode.
Click on the Save button to save your timer selection.
The Timer disabled setting allow you to disable the timer function for each question. The starting
and stopping of the quiz will be manually controlled by the instructor.
The Response Status Bar Setting allows the selection of the response status bar to be used in a
quiz. The default set is Normal. Select one of the timers you desire by clicking on its corresponding
radio button.
The Normal setting allows you to show all students response status bar.
The Update the status bar every 100 students and display the device ID of no answer setting
allows you to show 100 students response status bar alternately and display the device ID of no
answer at last.
The Enable the counter and the function of displaying the device ID of no answer setting
allows you to enable the counter to count the number of the response. After the number of no
answer is less than 50, the status bar will display the device ID of no answer.
The Automatically Start the Exam When Turned to Next Question allows you to start the next
question without pressing the Start/Pause
button each time you turn to the next question.
Note: This function is unavailable under free-style mode.

2.4.1.3 Interaction Setting

The Interaction setting contains the Student ID Display, Send Questions(not available in this
system), Student Re-answer Times and Display Report/Result at end of Question:
Copyright © 2007 -2011 All Rights Reserved by QOMO HiteVision.
www.qomo.com
101

Advertisement

Table of Contents
loading

Table of Contents