Controls & Components - Grizzly G0935 Owner's Manual

Controls &
Components
To reduce your risk of
serious injury, read this
entire
using machine.
Refer to the following figures and descriptions to
become familiar with the basic controls and com-
ponents of this machine. Understanding these
items and how they work will help you understand
the rest of the manual and minimize your risk of
injury when operating this machine.
3-Axis DRO
B C
Figure 1. 3-axis DRO.
A. 3-Axis DRO Display: Shows location and
movement of table and headstock along X-,
Y-, and Z-axes to within 0.001" or 0.001mm.
Measurements can be recorded starting any-
where along axis movement.
B.
: Press to zero selected axis.
C.
: Press to toggle between mm and inches.
D. : Press to toggle between absolute or rela-
tive measurement for selected axis.
E. : Button has no function on this machine.
F. : Press to change selected axis.
-4-
manual BEFORE
A
D E F
Spindle Control Panel
G
H
J
Figure 2. Spindle control panel.
G. Spindle Speed Tachometer: Shows spindle
speed from 80–5000 RPM.
H. FAULT Indicator: Illuminates if an operation
fault occurs, if E-STOP button is pressed, or
if headstock cover is removed. Headstock
cover must be in place to operate spindle.
Reset FAULT by resetting E-STOP button.
I. Spindle Speed Dial: Rotate to turn spindle
ON and OFF; varies spindle speed from
80–1700 RPM when belt is positioned for
low speed range; varies spindle speed from
280–5000 RPM when belt is positioned for
high speed range.
J. E-STOP Button: Press to stop spindle rota-
tion and disable power to spindle control
panel. Twist clockwise to reset.
K. FWD/OFF/REV Switch: Turn to FWD (1) to
rotate spindle clockwise. Turn to REV (2) to
rotate spindle counterclockwise. Turn to OFF
(0) to stop spindle.
Model G0935 (Mfd. Since 04/21)
I
K