Subscribe to Our Youtube Channel
Related Manuals for Xpelair CDC100P
Summary of Contents for Xpelair CDC100P
- Page 1 Installation and Maintenance Instructions Xpelair CDC100P Pull Cord Xpelair CDC100T Timer Xpelair CDC100HT Humidistat, Timer and Pull Cord Contour Range of Toilet / Bathroom Fans with Ultra DC motors...
- Page 3 Fan Speed Setting...
- Page 4 If you have any queries before installing these products or after they have been installed, call the Xpelair Technical Hotline +44 (0) 844 372 7766. Our engineers are there to help you during normal office hours (UK only) and may be faxed at all other times on +44 (0) 844 372 7767.
- Page 5 Mortar to make good the hole around the ducting. If ceiling mounting the fan, You will need the use of appropriate ancillaries for termination. These items are available from Xpelair: 1. WT10 – Termination ducting kit. 2. FD100 – Flexible Ducting.
- Page 6 Preparing the hole. If working above ground floor level, safety precautions must be observed. WARNING: EYE PROTECTION MUST BE WORN DURING ALL DRILLING AND CHISELLING OPERATIONS. If installing in a Wall. 1. Check there are no buried pipes or cables in the wall or obstructions on the outside e.g. electricity, gas, water.
- Page 7 To set the trickle speed to OFF, set the switch shown in Figure E (this is the switch marked 1 above it) to the UP position (away from the side of the switch marked ‘ON’). Setting the Delay Start – CDC100P / CDC100T / CDC100HT Only These fans can be set so that there is a 2-minute time delayed start.
- Page 8 UK only: We, Redring Xpelair Group Limited, provide a guarantee against faulty parts and manufacture for a period of 2 years with 5 years on the motor only, from the date of purchase. In the unlikely event of a product breakdown during the guarantee period please call our technical helpline on 0844 372 7766 for advice and assistance.
Need help?
Do you have a question about the CDC100P and is the answer not in the manual?
Questions and answers