Xpelair Simply Silent C6S Installation And Maintenance Instructions Manual
Contour fan
Hide thumbs
Also See for Simply Silent C6S:
Table of Contents
Advertisement
Quick Links
Contour Square Fan
D
o read the en�re instruc�on leaflet before commencing installa�on.
•
Do install each fan with a means for disconnec�on in all poles in the fixed wiring.
•
Do make sure the mains supply is switched off before a�emp�ng to make electrical connec�ons or carry out any
•
maintenance or cleaning.
Please leave this leaflet with the fan for the benefit of the user.
UK customers:
If you have any queries before or a�er installing this product call the Xpelair Technical Hotline +44 (0)
Customers outside the UK should contact your local Xpelair distributor.
. Our engineers are there to help you during normal office hours.
Standard
Timer
Pull Cord
Humidistat, Timer
Contour Round Fan
Advertisement
Table of Contents
Related Manuals for Xpelair Simply Silent C6S
Summary of Contents for Xpelair Simply Silent C6S
- Page 1 Please leave this leaflet with the fan for the benefit of the user. UK customers: If you have any queries before or a�er installing this product call the Xpelair Technical Hotline +44 (0) . Our engineers are there to help you during normal office hours.
- Page 2 Children shall not play with the appliance. Cleaning and maintenance of the appliance shall not be made by children. All Xpelair Simply Silent Contour AC fans have the following features: Two speed extrac�on (Selectable at installa�on) •...
- Page 3 Back plate fixing posi�ons Wall tube quickfix clamps Front Cover Removal Factory se�ngs: Timer 15 minutes, RH 75% Minimum 30 seconds Maximum 30 minutes...
- Page 4 Wiring and se�ng up...
- Page 5 If ceiling mounting the fan, you will also need: A 150mm diameter prepared hole. • Appropriate ancillaries for termina�on. These items are available from Xpelair: • 3m flexible duc�ng Ref: 89665AA. If the duct passes through a cold space use insulated duct ref: 91461AA.
- Page 6 For Australia Only –C6TS / C6TR / C6HTS / C6HTR These models are permanently connected to the supply and operation is controlled by a remote switch. They should be directly wired to the supply through an approved 10A wall mounted surface switch with at least 3mm clearance between contacts. Remove the front cover/baffle assembly by depressing the latch on the underside of the cover and pulling off...
- Page 7 SPEED SETTING The fans are factory set to low speed, but have two speed se�ngs for different applica�ons. Select either high or low speed by connec�ng the jumper between the centre and high or low speed pin on the jumper (see Figure E) C6TS / C6TR Only.
- Page 8 Telephone: +353 (0)1 8523400 Email: customer.services@glendimplex.com Email: serviceireland@glendimplex.com Web: www.xpelair.co.uk Warranty: Contact your local distributor or Xpelair direct for details. Technical advice and service: Contact your local Xpelair distributor. Xpelair: A brand of Glen Dimplex Hea�ng & Ven�la�on Part No:...
Need help?
Do you have a question about the Simply Silent C6S and is the answer not in the manual?
Questions and answers