Setting Commands; End Print Signal (Output) Mode Settings - Epson CW-C6000A Technical Reference Manual

Setting Commands

This section describes the commands for setting the external I/O.

End print signal (output) mode settings

[Format]
^S(CNA,B,c
[Parameter] c
Description
c = Mode setting
[Function]
Configure the mode settings for the end print signal.
Value for parameter c
D/0
1
E/2
3
N/4
[Initial value]
0
[Signal timing]
<Mode 1>
Signal
Data preparation
complete
Start print
End print
D/E/N/0/1/2/3/4
Turn the end print signal OFF. (End print signal not output)
Set the end print signal (pin 18) as follows: Normal: High,
When feeding paper: Low.
Set the end print signal (pin 18) as follows: Normal: Low,
When feeding paper: High.
Set the end print signal (pin 18) as follows: Normal: High,
When continuous printing ends and the printer stops at the predetermined position: Low
for 20 msec.
Set the end print signal (pin 18) as follows: Normal: Low,
When continuous printing ends and the printer stops at the predetermined position: High
for 20 msec.
Sent label Processed Standby for
format label format start signal
Definition range
Description
Printer status
Ready to print
Print label
Chapter 3 Commands
Signal status
next label
Preparing
Preparation
complete
Do not start
Start
Not finished
Finished
23
3