Table of Contents
Advertisement
INSTALLATION GUIDELINES
FLAMMABLE MATERIAL WARNING
Keep fixture minimum 5.0 feet (1.5m) away from flammable materials and/or pyrotech-
nics.
ELECTRICAL CONNECTIONS
A qualified electrician should be used for all electrical connections and/or installations.
USE CAUTION WHEN POWER LINKING OTHER MODEL FIXTURES AS THE
POWER CONSUMPTION OF OTHER MODEL FIXTURES MAY EXCEED THE MAX
POWER OUTPUT ON THIS FIXTURE. CHECK SILK SCREEN FOR AMX AMPS.
DO NOT INSTALL THE FIXTURE IF YOU ARE NOT QUALIFIED TO DO SO!
POWER LINKING OF UNITS OF THE SAME MODEL TYPE MAY ONLY BE
PERFORMED WHEN OPERATING ON 240-VOLT POWER. IN THIS INSTANCE,
DO NOT POWER LINK MORE THAN TWO (2) UNITS TOGETHER, INCLUDING
THE UNIT THAT IS CONNECTED DIRECTLY TO THE POWER SOURCE. NEVER
EXCEED THE MAX CURRENT AND POWER DRAW LISTED ON THE SILK
SCREEN.
DO NOT POWER LINK UNITS OF THE SAME MODEL TYPE WHEN OPERATING
ON 110-VOLT POWER!
•
Fixture MUST be installed following all local, national, and country commercial electrical and con-
struction codes and regulations.
•
Before rigging/mounting a single fixture or multiple fixtures to any metal truss/structure or placing
the fixture(s) on any surface, a professional equipment installer MUST be consulted to determine
if the metal truss/structure or surface is properly certified to safely hold the combined weight of
the fixture(s), clamps, cables, and accessories.
Fixture ambient operating temperature range is 14° to 113°F (-10° to 45°C). Do not operate this
•
fixture when ambient temperature falls outside of this range.
•
Fixture(s) should be installed away from walking paths, seating areas, or areas were unauthorized
personnel might reach the fixture by hand.
•
NEVER stand directly below the fixture(s) when rigging, removing, or servicing.
•
Overhead fixture installation must always be secured with a secondary safety attachment, such
as an appropriately rated safety cable.
•
Allow approximately 15 minutes for the fixture to cool down before servicing.
10
Advertisement
Table of Contents
