Daikin DV PTC 14 Series Installation Instructions Manual page 5

CMK0008 CMK0009
Condensate Condensate
Kit Kit
DV25PTCB14 DV29PTCB14 DV31PTCC14 DV49PTCD14 DV33PTCC14
DV37PTCB14 DV37PTCC14 DV61PTCD14 DV39PTCC14
Condensate Kit
6.3 Downflow/Horizontal Right Installation
IMPORTANT NOTE: In the downflow application, to prevent
coil pan "sweating", a downflow kit (DFK) is available through
your local Daikin distributor. The DFK is not supplied with the air
handler and is required by Daikin on all downflow installations.
See Downflow Kit table for the correct DFK and follow the
instructions provided for installation.
MODEL LIST FOR DOWNFLOW KITS
DFK-B
Downflow Kit Downflow Kit
DV25PTCB14** DV31PTCC14**
DV29PTCB14** DV37PTCC14**
DV35PTCB14** DV59PTCC14**
DV37PTCB14** DV33PTCC14**
DV39PTCC14**
DV49PTCC14**
Downflow Kit
Refer to Figure 6 and 7 for the location of the components
referenced in the following steps.
1. Before inverting the air handler, remove blower access panel
and coil access panel. The coil access panel and tubing
panel may remain screwed together during this procedure.
Remove and retain the seven (7) screws securing the coil
access panel to the cabinet and the six (6) screws securing
the blower access panel to the cabinet.
2. Slide the coil assembly out using the drain pan to pull the
assembly from the cabinet.
NOTE: DO NOT USE MANIFOLDS OR FLOWRATOR TO
PULL THE COIL ASSEMBLY OUT. FAILURE TO DO SO
MAY RESULT IN BRAZE JOINT DAMAGE AND LEAKS.
3. Removal of the center support is required on units with 21"
wide cabinet. Remove and retain the two (2) screws that
secure the center support to the cabinet. Remove the center
support.
CMK0010 CMK0012
Condensate Condensate Condensate
Kit Kit
DV37PTCD14
DV49PTCC14
DV59PTCC14
DV59PTCD14
Table 1
DFK-C DFK-D
Downflow Kit
DV37PTCD14**
DV49PTCD14**
DV59PTCD14**
DV61PTCD14**
Table 2
CMK0013
Kit
5