Connection & Installation; Connection Guide; Installation Guide - Amcrest IP2M-851EB User Manual

2mp ultrahd vandal dome poe camera

Hide thumbs Also See for IP2M-851EB:

Table of Contents

To access the reset button and to adjust the camera angle, use a Torx/Hex wrench to open the camera assembly by

removing the 3 screws.

For reference, a Torx/Hex screwdriver tip looks like this:

3 Connection & Installation

This section provides information about the connection and installation of your camera.

The camera initially should be connected via the following method:

This camera uses a POE cable to enable connection to the camera via a PC, as well as to power the camera.

To install the camera on a ceiling or wall, please reference the below diagram as well as the steps:

Note: Prior to installation, please ensure that the installation environment can support at least 3x the weight of the

camera + bracket.

Table of Contents

Need help?

Do you have a question about the IP2M-851EB and is the answer not in the manual?

Ip2m-851ew