Advertisement
Step 8
You will need
6 x Screws
2 x Slides
12mm (H14)
(H15)
Phillips Head
2 x Cam Bolts
Screwdriver
(H1)
8 x Dowels
Mallet
30mm (H3)
Note the position
of the rubber stopper
Attach 2 x separated slide tracks (H15-1) onto 2 x side panels (P3) with 6 x screws (H14),
using a phillips head screwdriver as shown.
Ensure the slide tracks (H15-1) are attached so the rubber stopper is positioned as shown.
Screw 1 x cam bolt (H1) into each side panel (P3), using a phillips head screwdriver as shown.
Insert 4 x dowels (H3) into 2 x side panels (P3) as shown.
Use a mallet to gently tap the dowels into place if needed.
fantasticfurniture.com.au
Separate the 2 x slide runners (H15-2) and slide tracks (H15-1)
from the slides (H15) by following the steps below:
Extend the slide runner (H15-2) all the way out.
Press down the plastic release lever on the slide and pull out
the slide runner (H15-2) completely.
H15
Slide runner H15-2
Adjust runner to access the screw holes.
H15-1
Please fasten the screws
through these holes for this step
H15-1
H1
H15-1
H3
Slide track H15-1
H3
H14
H14
(P3)
H3
H15
H3
H14
H15-1
2
X
Page 9
Advertisement
