PROSOURCEFIT DOORWAY PULL-UP BAR Instruction Manual & Exercise Manual page 4

ASSEMBLY INSTRUCTIONS
Measure the distance of your doorway to ensure the pull-up bar fits, holding
the bar with logo facing up, twist towards you on either end to lengthen the
bar and mark where the metal holder should go.
Secure a metal holder on the first side. Place a screw through the rubber limiter
and drill into the middle hole of the holder into doorframe. Use 3 more screws
to secure the metal bar holder. (Repeat
Once both metal bar holders are secure, place one end of the doorway pull-up
bar into the holders, then lengthen the other end by twisting towards you. Continue
to adjust until the pull-up bar is fitting tightly.
STEP 1
STEP 2
STEP 2
on the other side)
STEP 3