Getting Started; Turning On The Equipment - Vatech PaX-i Plus PCH-30CS User Manual

2.

Getting Started

2.1

Turning on the Equipment

The imaging system mainly consists of the imaging equipment and the PC.
Before turning on the equipment, please confirm that the equipment and PC have
been installed correctly.
1.
Turn on the PC.
2. Press the Main Power Switch that is located under the bottom of the Vertical
Frame to turn on the equipment.
3.
Make sure that the green LED light at the top of the equipment is on.
PaX-i Plus User Manual
Do not place the patient close to the equipment when it's

being turned on. Doing so may cause physical injury to
the patient and damage to the equipment.
Do not operate the PC while the equipment is in

operation. Doing so may cause an error on the
equipment.
Extreme fluctuation of temperature may cause

condensation inside the equipment. Do not switch on the
equipment until it has reached normal room temperature.
Rebooting the equipment: After turning it off, wait for

approx. 20 seconds before turning it on again.
Warm-up the equipment for at least 5 minutes before the

operation. For the best image quality, it is recommended
to have a warm-up phase for more than 30 minutes.
If the equipment has not been used for a long time, please
let it have enough time to be warmed up. It extends the life
of the X-ray tube.
Main Power Switch isolates its circuits electrically from the
supply mains on all poles simultaneously.
2. Getting Started
7