Using Atem Camera Converter; Status Indicators - Blackmagicdesign ATEM Camera Converter Installation And Operation Manual

Using ATEM Camera Converter

10
PGM
OPTICAL VIDEO
ATEM Camera Converter's control panel.
The tally lights on each side of the ATEM Camera Converter
glow red when your camera is live on the program output of an
ATEM production switcher.
OPTICAL
OPTICAL VIDEO
OPTICAL
Battery level, optical, and video signal status indicators.
All manuals and user guides at all-guides.com
PTT
PGM
VIDEO
PGM
PGM
VIDEO
Using ATEM Camera Converter
Using ATEM Camera Converter
ATEM Camera Converter's control panel features buttons for adjusting
volume, activating talkback, program/camera monitoring, powering on
camera number. There are also 5 status indicators for battery level, optical s
and tally.

Status Indicators

Tally lights
These lights illuminate when a tally signal is received from the program outp
watching the two red tally lights on opposite sides of ATEM Camera Convert
operator can see when they are on air.
Battery level
On the far left of the control panel are four green battery level indicators. T
indicators decrease as the battery level decreases. When the remainin
flashing, there's approximately 10 minutes of battery power left, so you s
power source or switch to another charged ATEM Camera Converter. The
hours of continuous use and requires approximately 8 hours for a comple
OPTICAL
Next to the battery level LEDs is the OPTICAL indicator. This lights up when
signal is detected by ATEM Camera Converter. Use this indicator to confirm PTT
is being sent or received.
VIDEO
The VIDEO indicator lights up when a valid SDI or HDMI video signal is d
Converter. Use this indicator to confirm that your camera input signal is present.
PTT
PTT