Audix MGN Series Manual

Micro-goosenecks

MGN Series

Micro-Goosenecks

OVERVIEW

The Micro-Gooseneck (MGN) series consists of 3 extension pieces for the Micros™

series condenser microphones. Each model is a lightweight tube with a mini-XLRf

connector on the top and a standard XLRm connector on the base. There are flexible

goosenecks at each end of the tube. There is balanced cable inside the tube, with pin

2 hot in respect to pin 3.

The MGN series is designed to work with any of the Micros™ series; M1250B,

M1255B, M1280.

There are three models: MGN6 is 6 inches (152mm) in length,

MGN-14 is14 inches (355mm) in length, MGN20 is 20 in (508mm)

in length.

MGN20

MGN14

MGN6

To assemble, place the mini-XLRm of the Micros™ series microphone against the mini-

XLRf end of the MGN tube. Line up the pins and push gently until the microphone

click/locks into place. The XLRm base can fit into any XLRf connector, or into the XLRf

port on the ATS10 or ATS1 weighted stand. (See Below)

[Product shown is an MGN6; assembly process is the same for each model.]

MGN SERIES

Table of Contents

Do you have a question about the MGN Series and is the answer not in the manual?

Page 1 There is balanced cable inside the tube, with pin 2 hot in respect to pin 3. The MGN series is designed to work with any of the Micros™ series; M1250B, M1255B, M1280. SUPPLIED ACCESSORIES...
Page 2 SERVICE AND WARRANTY: This product is under warranty for a period of 1 year to be free of defects in material and workmanship. In the event of a product failure due to materials or workmanship, Audix will repair or replace said product at no charge with proof of purchase. Audix does not pay or reimburse shipping costs for warranty repairs or returns. The warranty excludes any causes other than manufacturing defects, such as normal wear, abuse, environmental damage, shipping damage or failure to use or maintain the product per the supplied instructions.

Mgn6Mgn14Mgn20