Advertisement
9.
Connect both transformer cable and hand controller cable to the two
mattress elevator leads attached to the actuator (motor).
10. Having ensured the power cables are routed safely towards the head
end of the bed, insert the mains lead into the power supply. Then, insert
the mains plug into the power socket. Power on is indicated by a green
light on the transformer.
11. The mattress elevator is ready for use.
Instructions for use
Using the hand controller, press and hold the left hand button to raise the
mattress elevator to the desired position.
The mattress elevator can be stopped and used at any angle.
To lower the mattress elevator, press and hold the left hand button on the
hand controller. See hand controller diagram below.
Always unplug the unit from the mains supply when not in use.
Issue 2: 17/08/2017 MILLBROOK INDUSTRIES LTD
5
Advertisement
