Advertisement
Assembly and fitting
Prior to installation, ensure your mattress elevator is suitable for your local
supply, i.e. 230 Volts 50Hz and UK 3-pin socket (BS1363)
1.
Ensure that the bed to which the Ultimate Healthcare mattress elevator is
fitted has a base of suitable strength and rigidity to support the product.
2.
Having removed the mattress from the bed, place the mattress elevator
on the headboard end of the bed base with the chrome bars uppermost.
3.
The end of the base frame should be placed approximately 80mm from
the end of the bed.
4.
The two chrome bars are adjustable; these need to be set to suit the
width of mattress. To do this, remove the four e-clips on the top and
bottom bars of the mattress frame and extend to approximately 50mm
inside the edge of the mattress. This will ensure full support. Once done
so, replace the e-clips.
5.
Note the Ultimate Healthcare mattress elevator has colour-matched
retaining straps to identify where they should be fastened.
6.
Secure the mattress elevator base section to the bed base using:
•
•
Following step 6, ensure straps are tensioned fully and the mattress elevator is
retained firmly in place. See picture below.
Issue 2: 17/08/2017 MILLBROOK INDUSTRIES LTD
The single blue strap along the length and looped under the base.
The two green straps across the width and looped under the base.
3
Advertisement
