Installing A Memory Upgrade Module; Checking The Memory Capacity - Fujitsu Lifebook MH380 User Manual

Installing a Memory Upgrade Module

1
Remove the new memory upgrade module from
the static guarded sleeve.
2
Align the memory upgrade module with the
component side up. Align the connector edge of
the memory upgrade module with the connector
slot in the compartment.
3
Insert the memory upgrade module at a 45° angle.
Press the connector edge of the module firmly
down and into the connector until it lodges under
the retaining clip. You will hear a click when it is
properly in place.
4
Replace the cover., then replace the screws.
T
HE MEMORY UPGRADE MODULE IS NOT SOMETHING YOU ROUTINELY REMOVE FROM YOUR NOTEBOOK
O
NCE IT IS INSTALLED
MEMORY CAPACITY

Checking the Memory Capacity

Once you have changed the system memory capacity by replacing the installed module with a larger one,
be sure to check that your mini-notebook has recognized the change.
Check the memory capacity by clicking [Start] > Control Panel, then clicking the System icon. On the
main screen, check the amount of memory under System, next to Installed memory (RAM):
I
F THE TOTAL MEMORY DISPLAYED IS INCORRECT
PROPERLY INSTALLED
CORRECTLY RECOGNIZED
,
YOU SHOULD LEAVE IT IN PLACE UNLESS YOU WANT TO CHANGE SYSTEM
.
. (I
F THE MODULE IS PROPERLY INSTALLED AND THE CAPACITY IS STILL NOT
, T
SEE ROUBLESHOOTING ON PAGE
58 - Memory Upgrade Module
Figure 20. Installing a Memory Module
,
CHECK THAT YOUR MEMORY UPGRADE MODULE IS
63.
.