Shutdown And Startup Problems - Fujitsu Lifebook MH380 User Manual

Problem
The battery seems to 
discharge too quickly.
(continued)

Shutdown and Startup Problems

The Suspend/Resume 
button does not work.
The system powers up,
and displays power on
information, but fails to
load the operating system.
An error message is 
displayed on the screen
during the boot sequence.
Your notebook appears to
change setup parameters
when you start it.
Possible Cause
The brightness is turned all
the way up.
Battery has been exposed to
high temperatures.
The battery is too hot or too
cold.
Suspend/Resume button is
disabled.
There may be application
software conflict.
The boot sequence settings
of the setup utility are not
compatible with your configu-
ration.
You have a secured system
requiring a password to load
your operating system.
Power On Self Test (POST)
has detected a problem.
BIOS setup changes were not
saved when made and you
exited the setup utility.
70 - Troubleshooting Your Mini-notebook
Possible Solutions
Turn down the brightness adjustment. The higher the bright-
ness the more power your display uses.
Replace the battery.
Restore the notebook to normal operating temperature.
Charging icon on the Status Indicator panel will flash when
battery is outside of operating range.
Enable the button by going to the Control Panel > Power
Options Properties and clicking on the Advanced tab. In the
Power buttons area, select the option that suits your needs.
Close all applications and try the button again.
Set the operating source by pressing the [ESC] key while the
Fujitsu logo is on screen or use the [F2] key and enter the
setup utility and adjust the source settings from the Boot
menu. See "BIOS Setup Utility" on page 43.
Make sure you have the right password. Enter the setup util-
ity and verify the Security settings and modify them as
accordingly. See "BIOS Setup Utility" on page 43.
See the Power On Self Test (POST) messages to determine
the meaning and severity of the problem. Not all messages
are errors; some are simply status indicators. See "Power On
Self Test Messages" on page 73.
Make sure you select Save Changes And Exit when exiting
the BIOS setup utility.