Table of Contents
Advertisement
Quick Links
INSTRUCTION MANUAL
Electric Fuel Pump
FPM
FPM-12, FPM-12/HF, FPM-24, FPM-115, FPM-220
Congratulations on purchase of this World Class Electric Fuel Pump!
Pump
Outlet
Swivel
Nut
Suction Tube
Pad Lock
Fuel
Nozzle
Elbow
Lever
Control
Holder
Nozzle
OFF
ON
Switch
Motor
Hose
This is an Electric Fuel Pump. Pump uses 2 Sintered Powder
Metal gears for suction & is designed for use with Gasoline,
Diesel, E15 Fuel, Kerosene, Bio Diesel (B20) etc. In ideal
laboratory conditions, pump dispenses up to 15 GPM (57 LPM)
at the pump outlet. In case of High Flow Model FPM/12/HF,
discharge is 20 GPM (75 LPM). The actual discharge varies
depending on fuel being used, temperature, Hose Length,
power supply etc.
Pump Comes in 4 Power Ratings
•
12V DC
•
24V DC
•
115V AC, 60 Hz.
•
220V AC , 50/ 60 Hz
Rating is marked on the pump motor.
1
S1590, Rev B
D SERIES
Inside of
Pump
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Groz D Series
Summary of Contents for Groz D Series
- Page 1 INSTRUCTION MANUAL S1590, Rev B Electric Fuel Pump D SERIES FPM-12, FPM-12/HF, FPM-24, FPM-115, FPM-220 Congratulations on purchase of this World Class Electric Fuel Pump! Pad Lock Fuel Nozzle Elbow Lever Control Holder This is an Electric Fuel Pump. Pump uses 2 Sintered Powder Nozzle Metal gears for suction &...
- Page 2 PUMP CONSTITUENTS 1. Pump & Motor Assembly 2. Nozzle Holder 3. Elbow 4. Suction Tube (2 parts) 5. Bung Nut 6. Hose Assembly (12’ Long x ¾” ID Anti Static Hose) 7. Fuel Control Nozzle 8. Gland Nut 9. Power Cord complete with Fuse & Clamps* 10.PTFE Tape *Only included on DC pumps.
-
Page 3: Assembly And Installation
12. Re-install 14. Attach battery Electrical Cover clamps with red on the pump & sleeve to red wire tighten using the & black sleeve to 4 bolts black wire. Wire must be crimped to the battery clamp firmly to get a good electrical connection 13. - Page 4 3. Now Fasten the 7. Lift the Pump from the Elbow into the Elbow Pump Outlet motor. Be careful as the pump outlet & assembly is heavy. Insert hand tighten. Once suction tube into the drum you can no longer through the 2”...
-
Page 5: Pump Operation
PRIMING All pump models using the supplied 34” (865mm) suction tube 1. Remove the Elbow from the pump outlet should prime within 10 seconds after pump is turned on. 2. Pour fuel being pumped into the pump outlet until completely Pumps installed at a height upto 5’... - Page 6 EXPLODED VIEW FOR FPM-12, FPM-12/HF, FPM-24, FPM-115, FPM-220 PUMP ASSEMBLY HOSE, SUCTION TUBE, POWER CABLE & FUEL CONTROL NOZZLE ASSEMBLY...
- Page 7 PARTS LIST FOR FPM-12, FPM-12/HF, FPM-24, FPM-115, FPM-220 PUMP ASSEMBLY REFERENCE NUMBER DESCRIPTION QUANTITY Thread Forming Bolt M4 Cover (Strainer) O-Ring Strainer Thread Forming Bolt M8 Housing Cover O-Ring Gear Key Gear Shaft (Gear) Housing (Machined) Fitting (Bung) Swivel Nut Bung Adaptor Seal (Metal Inserted) Circlip...
-
Page 8: Pump Specification
PUMP SPECIFICATION FPM-12 FPM-12/HF FPM-24 FPM-115 FPM-220 Description Heavy Duty 12V DC High Flow 12V DC Heavy Duty 24V DC Heavy Duty 115V AC Heavy Duty 220V AC Flow Rate* Up to 15 GPM Up to 20 GPM Up to 15 GPM Up to 13 GPM Up to 13 GPM (57 LPM) -
Page 9: Troubleshooting
TROUBLESHOOTING PROBLEM CAUSE SOLUTION Motor rotation wrong. (12 VDC and 24 VDC Check wiring instructions for possible problems units only) Missing relief valve o-ring seal (16) Remove gear cover (6), inspect seal, replace if missing or damaged Sheared drive key (9) Remove cover (6) and inspect key, replace if worn or sheared Dirt under by-pass valve (17) or seal (16) Remove cover (6) and inspect, clean or replace if damaged... - Page 10 REPLACEMENT & SERVICE PARTS PROGRAM FOR ELECTRIC FUEL PUMPS REPLACEMENT PARTS PROGRAM REFERENCE # FROM OIPM GROZ PART # DESCRIPTION MOT/FPM/12 Motor, 12V DC MOT/FPM/12/HF Motor, 12V DC HF MOT/FPM/24 Motor, 24V DC MOT/FPM/115 Motor, 115V AC, 60 Hz MOT/FPM/220...
- Page 11 SERVICE PARTS PROGRAM CONSTITUENT CONSTITUENT QTY. SUPPLY KIT PART # CONSTITUENT DESCRIPTION REFERENCE DESCRIPTION PART # PER KIT CONDITION FROM OIPM ORG/BS154 O Ring ORG/V/BS809 O Ring (Viton) FPM/KIT/SK Seal Kit ORG/BS126 O Ring SEL/FPM/12 Seal (Metal Inserted) CCL/FPM Circlip GEAR/FPM/12 Gear FPM/KIT/GK...
- Page 12 Village Kherki Daula, National Highway-8 Gurgaon-122001, Haryana, INDIA TEL +91.124.282.7700 / 221.4050 FAX +91.124.2827986 / 221.4224 FAX (USA) +1.509.271.7848 FAX (UK) +44.870.121.1854 E-MAIL info@groz-tools.com www.groz-tools.com The Groz name, Groz logo and the mark are trademarks of Groz Engineering Tools (P) Ltd. India...
Need help?
Do you have a question about the D Series and is the answer not in the manual?
Questions and answers