Table of Contents
Advertisement
RUGGEDCOM WIN7225
Installation Guide
Device Management
This section describes how to connect to and manage the base station.
CONTENTS
•
Section 3.1, "Connecting to the Base Station"
•
Section 3.2, "Configuring the Base Station"
Section 3.1
Connecting to the Base Station
The following describes the various methods for accessing the RUGGEDCOM WIN console and Web interfaces on
the base station. For more detailed instructions, refer to the RUGGEDCOM WIN User Guide for the base station.
Accessing Boot-Time Control and CLI
To access the boot-time control and RUGGEDCOM WIN CLI, connect a PC or terminal directly to the serial console
port.
IMPORTANT!
The serial console port is intended to be used only as temporary connections during initial
configuration or troubleshooting.
CAUTION!
Environmental hazard – risk of damage due to the ingress of water, dirt or debris. The serial console
port is protected by a cover from the ingress of harmful water, dirt or debris. Make sure this cover is
securely attached when the port is not in use.
The serial console port is a proprietary RJ45 female connector. The following is the pin-out for the connector:
NOTE
A custom console cable is provided with the base station.
1
Figure 19: RJ45 Connector Pin Configuration
Connecting to the Base Station
Pin
1
2
8
3
4
5
Device Management
Name
Description
Reserved (Do Not Connect)
RX
Receive Data
TX
Transmit Data
Reserved (Do Not Connect)
Reserved (Do Not Connect)
Chapter 3
27
Advertisement
Table of Contents
