Memory Upgrade Module - Fujitsu 770Tx User Manual

Figure 4-11 Opening the Memory Upgrade Compartment
Figure 4-12 Removing a Memory Upgrade Module
U s e r I n s t a l l a b l e

MEMORY UPGRADE MODULE

Your notebook has 32MB of installed SDRAM.
To increase your memory capacity you may
install a memory upgrade module in the mem-
ory upgrade compartment in the bottom of
your notebook. The memory upgrade module
is a Small Outline dual-in-line memory module
(SODIMM). You may add modules of different
capacity. SDRAM modules are recommended
but EDO modules will work. Installing an EDO
module will cause your system to operate at a
slower rate.
C A U T I O N
Never remove screws except the ones
specifically shown in the directions for
installing and removing the memory
upgrade module.
L i f e B o o k 7 0 0 S e r i e s f r o m F u j i t s u
F e a t u r e s
To Install a Memory Upgrade Module:
1. Turn off power to your notebook using
the power switch, (see Power Off on pages
24-25), and remove any power adapter
(AC or auto/airline).
2. Make sure that all the connector covers
are closed.
3. Turn the notebook bottom side up, with the
front panel toward you.
4. Remove the screws at the front of the
memory upgrade module compartment.
(See Figure 4-11.)
5. Remove the cover by tilting the front edge
up and then pulling forward until the tabs
on the cover are free. (See Figure 4-11.)
6. Remove the memory upgrade module from
the static guarded sleeve.
129